A glider chair and ottoman without a Glider Skirt™ is not complete… or safe.
Step by Step Instructions
Takes an estimated 5-10 mins to install a complete set
(Glider Chair and Ottoman)
Peel off adhesive backing and install the longer pieces all around the perimeter of the chair by pressing down firmly.
Peel off adhesive of the shorter two pieces and install along the two glider linkages at the bottom, on either side of the chair. Press down.
Take the skirt garment, find the two edge box pleats with your fingers.
Install the front panel along the front of the chair with pleats at each corner. Press down firmly so the Velcro hooks.
Install in a similar way on either side of the chair. If your chair has a brake, notice the slit at the top of the skirt allowing you to install around it - if your chair does not have a brake then just close the slit tightly by pressing down into the velcro.
Lift the garment on either side and install the protective panels by pressing down on those panels to connect them firmly to the velcro you installed on the gliding linkages at the bottom, on either side of the chair. This step is very important
Close the back of the skirt by pressing down along the velcro on the end lip of the skirt.
Step back and admire your handiwork.
Peel off adhesive backing on Velcro pieces and install longer pieces along either side of the ottoman.
Find the two edges of the ottoman skirt by centering the pleat in the front of your ottoman as shown.
Smooth down along the sides of the ottoman to install.
Lift the garment on either side and install the protective panels by pressing down on those panels to connect them firmly to the velcro you installed on the gliding linkages at the bottom, on either side of the ottoman. This step is very important
Close the back of the ottoman garment by matching up and pressing down on the velcro along the end lip of the garment.
Yay, you're done Happy gliding
Machine wash alone, on gentle/cold water setting, lay flat to dry (no dryer).
Use a warm iron as desired.